Siemens Sinumerik 840D sl Diagnostic Manual page 477

03/2009
61213 [Channel %1: ] Block %2: Circle radius too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The programmed circle radius is too small.
Alarm triggered by following cycles: CYCLE77, E_CR_HEL, E_PI_CIR, E_PO_CIR, E_PO_REC,
F_PI_CIR, F_PO_CIR, F_PO_REC
Remedy: Correct the circle radius, center point or end point.
61214 [Channel %1: ] Block %2: No pitch programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No thread/helical pitch has been entered.
Alarm triggered by following cycles: E_CR_HEL, E_PO_CIR, E_PO_REC, F_PO_CIR, F_PO_REC.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Program a pitch.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61215 [Channel %1: ] Block %2: Unfinished dimension incorrectly programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Check the blank spigot dimensions. The blank spigot must be larger than the production part spigot.
Alarm triggered by following cycles: CYCLE76, CYCLE77, E_PI_CIR, E_PI_REC, E_PO_CIR,
E_PO_REC, F_PI_CIR, F_PI_REC, F_PO_CIR, F_PO_REC
Remedy: Check parameters _AP1 and _AP2.
61216 [Channel %1: ] Block %2: Feed/tooth only possible with cutting tools
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Feed per tooth is only possible with milling tools.
Alarm triggered by following cycles: E_TFS, F_TFS.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: As alternative, set a different feed type.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61217 [Channel %1: ] Block %2: Cutting speed programmed for tool radius 0
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: To be able to work with cutting speed, the tool radius has to be specified.
Alarm triggered by following cycles: E_DR_SIN, E_DR_TAP, E_TFS, F_DR_SIN, F_DR_TAP,
F_DRILLC, F_DRM_TA, F_TAP, F_TFS
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Enter a value for cutting speed.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-477