Siemens Sinumerik 840D sl Diagnostic Manual page 541

03/2009
Definitions: Alarm triggered by following cycle: CYCLE800.
Note on 62180 and 62181:
Sample display of the swivel angle to be set for a manual rotary axis in CYCLE800:
62181 "Set rotary axis B: 32.5 [grd]"
Remedy: Settable angle for manual rotary axis.
62182 [Channel %1: ] Block %2 : load inclinable head: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No swivel head is active. Alarm triggered by following cycles: E_TCARR, F_TCARR.
Reaction: Alarm display.
Remedy: Request to load a swivel head.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
62183 [Channel %1: ] Block %2 : unload inclinable head: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE800.
Reaction: Alarm display.
Remedy: --
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
62184 [Channel %1: ] Block %2 : replace inclinable head: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE800.
Reaction: Alarm display.
Remedy: --
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
62185 [Channel %1: ] Block %2 : angle adapted to angle grid: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: %4 difference angle with Hirth tooth system
Alarm triggered by following cycle: CYCLE800.
Remedy: Check commissioning of swivel CYCLE800.
62186 [Channel %1: ] Block %2: No swiveling in JOG -> WO G%4 active and
total basic WO (G500) contain rotations
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE800.
On swiveling in JOG no rotation can be written to the work offset WO,
if rotations are already contained in the total basic WO or in the basic reference
Error 62186 message can be masked -> see setting data 55410
$SCS_MILL_SWIVEL_ALARM_MASK
Remedy: %4 number of the active work offset WO.
62187 [Channel %1: ] Block %2: Swiveling in JOG --> G500 active and total
basic WO or basic reference contain rotations
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE800.
During swiveling in JOG, it is not possible to write a rotation into the work offset WO,
if, with active G500, rotations are already contained in the total basic WO or in the basic reference
Error message 62187 can be masked -> see setting data 55410
$SCS_MILL_SWIVEL_ALARM_MASK
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-541