Siemens Sinumerik 840D sl Diagnostic Manual page 339

03/2009
Program Con- Switch control OFF - ON.
tinuation:
20200 [Channel %1: ] Invalid spindle number %2 with tool fine compensation
Parameters: %1 = Channel number target channel
%2 = Spindle number
Definitions: There is no spindle/axis assignment in the target channel for the spindle specified in the PUTFTOC
command.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Modify program in channel that writes the tool fine compensation.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
20201 [Channel %1: ] Spindle %2 no tool assigned
Parameters: %1 = Channel number
%2 = Spindle number
Definitions: In order to make allowance for the fine tool compensation for the tool currently in the spindle, a spin-
dle/tool assignment must be active. This is not presently the case for the programmed spindle in the
target channel of fine tool compensation.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: 1. Modify the part program (write the tool fine compensation).
2. Establish spindle/tool assignment by programming:
- TMON (tool monitoring)
- GWPSON (tool selection)
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
20203 [Channel %1: ] No active tool
Parameters: %1 = Channel number
Definitions: A tool fine compensation has been written for the active tool of channel %1 with PUTFTOC. No tool
is active in this channel. Therefore, the compensation cannot be assigned.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Correct the program.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
20204 [Channel %1: ] PUTFTOC command not allowed with FTOCOF
Parameters: %1 = Channel number
Definitions: A tool fine compensation has been written for channel %1 with PUTFTOC. The tool fine compensation
is not active in this channel. FTOCON must be active in the target channel of the PUTFTOC com-
mand.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Correct the program in the machining channel: Select FTOCON so that the channel is ready to receive
the PUTFTOC command.
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-339