Siemens Sinumerik 840D sl Diagnostic Manual page 535

03/2009
61933 [Channel %1: ] Block %2: Too many contour elements
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE63, CYCLE64
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Modify contour programming and thereby try to reduce the number of contour elements
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61934 [Channel %1: ] Block %2: Programming of the machining plane not
allowed here
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE63, CYCLE64
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Modify contour programming
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61935 [Channel %1: ] Block %2: Programming of the inch/metric measuring
system not allowed here
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE63, CYCLE64
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Modify contour programming
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61936 [Channel %1: ] Block %2: G0 is not allowed in contour programming
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE63, CYCLE64
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Modify contour programming, replace G0 by G1
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61937 [Channel %1: ] Block %2: Pocket depth programmed incorrectly
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE63
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Check parameter Z1
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-535