Siemens Sinumerik 840D sl Diagnostic Manual page 74

Overview of Alarms
NCK alarms
6583 NC system memory full
Definitions: The DRAM file system of the system area (Siemens) is full. The order cannot be executed.
Reaction: Alarm display.
Remedy: Delete or unload files (e.g. parts programs)
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
6584 NC memory limit TMP reached
Definitions: The DRAM file system of the TMP (temporary) area is full. The job cannot be executed.
Reaction: Alarm display.
Remedy: Increase MD18351 $MN_MM_DRAM_FILE_MEM_SIZE or switch off the precompilation of individual
or all cycles or, if need be,
delete the files in the TMP area.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
6585 NC external memory limit reached
Definitions: The DRAM file system of the external area (execution of the external drive) is full.
The job cannot be executed.
Reaction: Alarm display.
Remedy: Load the files to be executed explicitly into the NCK.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
6693 File %1 lost
Parameters: %1 = File name
Definitions: Due to a power failure, a file change could not be terminated properly. The file is lost.
Reaction: NC not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Import the file again.
Program Con- Switch control OFF - ON.
tinuation:
6700 [Channel %1: ] Value of the machine data %2%3 is too low
Parameters: %1 = Channel number
%2 = MD identifier
%3 = If required, field index
Definitions: The MD28302 $MC_MM_PROTOC_NUM_ETP_STD_TYP specifies the number of default event
types for the protocol users. However, more types are used than configured.
Reaction: Alarm display.
Remedy: Increase MD28302 $MC_MM_PROTOC_NUM_ETP_STD_TYP.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
7000 Too many compile cycle alarms defined
Definitions: Too many alarms are defined for the compile cycles. On powering up, the quantity was exceeded
when defining a new CC alarm.
Reaction: Alarm display.
Remedy: Apart from reducing the number of CC alarms, no remedial measures are possible at the present time.
(contact SIEMENS AG, System Support for A&D MC products, Hotline (Tel.: see alarm 1000)
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
2-74
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009