Siemens Sinumerik 840D sl Diagnostic Manual page 492

Overview of Alarms
NCK alarms
Definitions: The starting point of machining is outside the retraction planes.
Alarm triggered by following cycle: F_SP_RP.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Adjust the retraction planes.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61282 [Channel %1: ] Block %2: end point of machining outside retraction
planes
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The end point of machining is outside the retraction planes.
Alarm triggered by following cycle: F_SP_RP.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Adjust the retraction planes.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61283 [Channel %1: ] Block %2: direct approach not possible, as tool change
required
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: After block search a position is to be reached by direct approach, but a tool change is required before.
Alarm triggered by following cycle: F_TFS.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: First execute a manual tool change, then restart the block search.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61284 [Channel %1: ] Block %2: starting point cannot be approached without
collision. Pre-position tool manually
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The starting point cannot be approached without collisions.
Alarm triggered by following cycles: F_DRILL, F_DRILLC, F_DRILLD, F_DRM_DR, F_DRM_PE,
F_DRM_RE, F_DRM_SI, F_DRM_TA, F_GROOV, F_MIM_TR, F_PARTOF, F_SP_EF, F_TAP,
F_TR_CON, F_UCUT_T.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Preposition the tool manually.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61285 [Channel %1: ] Block %2: parking position is below return plane XRA.
Parameters: %1 = Channel number
%2 = Block number, label
2-492
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009