Siemens Sinumerik 840D sl Diagnostic Manual page 316

Overview of Alarms
NCK alarms
18300 [Channel %1: ] Block %2 frame: fine shift not possible
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Allocation of a fine shift to settable frames or the basic frame is not possible since MD18600
$MN_MM_FRAME_FINE_TRANS is not equal to 1.
Reaction: Interpreter stop
Interface signals are set.
Alarm display.
Remedy: Please inform the authorized personnel/service department. Modify program or set MD18600
$MN_MM_FRAME_FINE_TRANS to 1.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
18310 [Channel %1: ] Block %2 frame: illegal rotation
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Rotations are not possible with NCU global frames.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Modify part program.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
18311 [Channel %1: ] Block %2 frame: illegal instruction
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: An attempt was made to read or write a frame which does not exist.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Modify part program.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
18312 [Channel %1: ] Block %2 frame: fine shift not configured
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Fine shift must be configurd with G58 and G59.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Modify machine data.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
18313 [Channel %1: ] Block %2 frame: illegal switchover of geometry axes
Parameters: %1 = Channel number
%2 = Block number, label
2-316
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009