Siemens Sinumerik 840D sl Diagnostic Manual page 476

Overview of Alarms
NCK alarms
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61205 [Channel %1: ] Block %2: Position cycle unknown
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The specified positioning cycle in the machining block is unknown.
Alarm triggered by following cycles: E_MANAGE, F_MANAGE.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Delete and reprogram the positioning block.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61210 [Channel %1: ] Block %2: Block search element not found
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The element specified for the block search does not exisit.
Alarm triggered by following cycles: E_MANAGE, E_PS_CIR, E_PS_MRX, E_PS_POL, E_PS_SEQ,
E_PS_XYA, F_MANAGE, F_PS_CIR, F_PS_MRX, F_PS_SEQ
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Repeat block search.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61211 [Channel %1: ] Block %2: Absolute reference missing
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: An incremental indication was made, but the absolute reference is unknown.
Alarm triggered by following cycles: E_MI_CON, E_MI_PL, E_PI_CIR, E_PI_REC, E_PO_CIR,
E_PO_REC, E_PS_CIR, E_PS_HIN, E_PS_MRX, E_PS_POL, E_PS_SEQ, E_PS_XYA, E_SL_CIR,
E_SL_LON, F_PS_CIR, F_PS_MRX, F_PS_SEQ
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Program an absolute position prior to using incremental indications.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61212 [Channel %1: ] Block %2: Wrong tool type
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The tool type is not suitable for machining.
Alarm triggered by following cycles: CYCLE63, CYCLE64, CYCLE92, CYCLE951, CYCLE952,
E_DR, E_DR_O1, E_DR_PEC, E_DR_SIN, E_MI_TXT, F_DR, F_DR_PEC, F_DR_SIN, F_DRILL,
F_DRILLC, F_DRILLD, F_DRM_DR, F_DRM_PE, F_DRM_SI, F_GROOV, F_MI_TXT, F_MT_LEN,
F_PARTOF, F_ROU_Z, F_ROUGH, F_SP_EF, F_TAP, F_TR_CON, F_UCUT_T
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Select a new tool type.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
2-476
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009