Siemens Sinumerik 840D sl Diagnostic Manual page 608

Overview of Alarms
HMI-Alarms
112505 Error on interpreting contour:%n%1
Parameters: %1 = Contour name
Definitions: Contour is faulty.
Reaction: NC Start disable in this channel.
Alarm display.
Remedy: Check the contour's machining sequence.
Program Con- Internal
tinuation:
112506 Maximum number of contour elements exceeded:%n%1
Definitions: The maximum permissible number of 50 contour elements was exceeded when interpreting the
machining sequence of a contour.
Reaction: Alarm display.
Remedy: Check the contour's machining sequence and, if necessary, edit it.
Program Con- Internal
tinuation:
112541 Program cannot be interpreted
Definitions: The program cannot be interpreted as a ShopMill program during loading, as the program header is
missing.
Reaction: NC Start disable in this channel.
Alarm display.
Remedy: --
Program Con- Internal
tinuation:
112542 GUD variable does not exist or%narray dimension too small:%1
Definitions: The required GUD variable was not found on read or write access.
Reaction: Alarm display.
Remedy: Load the correct GUD variable.
Program Con- Internal
tinuation:
112543 Prog. was created with higher software version
Definitions: The part program has been created with a software version higher than the existing one.
Reaction: Alarm display.
Remedy: Delete the machining step and reprogram machining if required.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
112544 Program cannot be opened.%nIt is already being edited.
Definitions: Program is already open in HMI Advanced (Program or Services operating area).
Reaction: Alarm display.
Remedy: Close program in HMI Advanced (Program or Services operating area).
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
112546 Program cannot be opened.%nNo read access to the file.
Definitions: The file has no write access for the current access level.
Reaction: Alarm display.
Remedy: Set read access with keyswitch or via password.
Program Con- Internal
tinuation:
112550 Sequencer programming is not opened.
Definitions: Option 'Sequencer programming' has not been set.
Reaction: Alarm display.
Remedy: The program is opened as G code.
2-608
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG 2009 All Rights Reserved
03/2009