Siemens Sinumerik 840D sl Diagnostic Manual page 610

Overview of Alarms
HMI-Alarms
112605 Asynchronous subprogram was%nnot executed
Definitions: The input values could not be correctly processed by the NC.
Reaction: Alarm display.
Remedy: Perform an NCK reset
Program Con- Internal
tinuation:
112611 NC start not possible:%nDeselect single block
Definitions: A program was activated with block search while a single block has been active.
Reaction: Alarm display.
Remedy: Deselect the single block.
Program Con- Internal
tinuation:
112620 Language %1 not installed.
Definitions: Language not installed.
Reaction: Alarm display.
Remedy: Install language.
Program Con- Internal
tinuation:
112650 Unknown PLC error
Definitions: The PLC has announced an error that is unknown in the operator panel.
Reaction: NC Start disable in this channel.
Alarm display.
Remedy: Press POWER ON, inform Siemens.
Program Con- Internal
tinuation:
112999 Faulty graphic data. Exit graphic %nand restart
Definitions: More data was generated than can be read from the operator panel.
Stop the graphic.
Remedy: Deselect the graphic and then select it again.
113000 Invalid value - value range: %1
Parameters: %1 = --
Definitions: --
Remedy: --
113001 Incorrect configuration in line %1
Parameters: %1 = --
Definitions: --
Remedy: --
113002 Insufficient access level!
Definitions: --
Remedy: --
113003 Error when writing variable %1
Parameters: %1 = --
Definitions: --
Remedy: --
113004 Insufficient dynamic memory
Definitions: --
Remedy: --
113005 Incorrect NC file positioning: %1
Parameters: %1 = --
2-610
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG 2009 All Rights Reserved
03/2009