Siemens Sinumerik 840D sl Diagnostic Manual page 444

Overview of Alarms
NCK alarms
Program Con- Switch control OFF - ON.
tinuation:
27299 PROFIsafe: Diagnostics %1 %2 %3 %4
Parameters: %1 = Error code 1
%2 = Error code 2
%3 = Error code 3
%4 = Error code 4
Definitions: Internal error in the NCK PROFIsafe implementation.
Reaction: Alarm display.
Remedy: Make a note of the error text and contact Siemens A&D MC, Hotline
- Tel 0180 / 5050 - 222 (Germany)
- Fax 0180 / 5050 - 223
- Tel +49-180 / 5050 - 222 (International)
- Fax +49-180 / 5050 - 223
- email techsupport@ad.siemens.de
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
27300 F_DP: Cycle time %1 [ms] is too long
Parameters: %1 = Parameterized cycle time
Definitions: The F_DP communication cycle time resulting from MD $MN_SAFE_SRDP_IPO_TIME_RATIO and
$MN_IPO_CYCLE_TIME exceeds the permissible limit value of 250ms.
Reaction: Mode group not ready.
Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Correct cycle time via MD $MN_SAFE_SRDP_IPO_TIME_RATIO and/or $MN_IPO_CYCLE_TIME
Program Con- Switch control OFF - ON.
tinuation:
27301 F_DP: MD %1[%2]: SPL interface faulty
Parameters: %1 = MD name
%2 = MD array index
Definitions: The SPL interface in the displayed MD is incorrect: Possible causes:
- Bit values greater than definition of SPL interface (bit value > 64)
- Number of bits too high (upper bit value - lower bit value > 16)
- No SPL assignment parameterized (both bit values equal to zero)
- Incorrect SPL assignment (bit value equals zero)
Reaction: Mode group not ready.
Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Correct the MD.
Program Con- Switch control OFF - ON.
tinuation:
27302 F_DP: Double assignment MD %1[%2] - MD %3[%4]
Parameters: %1 = MD name 1
%2 = MD array index for MD name 1
%3 = MD name 2
%4 = MD array index for MD name 2
2-444
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009