Siemens Sinumerik 840D sl Diagnostic Manual page 499

03/2009
Remedy: No name assigned to the axis number specified in the parameter of the rotary axis (_RA), or this axis
is not configured as a rotary axis.
Check MD 20080 and MD 30300.
61330 [Channel %1: ] Block %2: Coordinate rotation active
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No measuring possible in the rotated coordinate system. Alarm is triggered: CYCLE972, CYCLE973,
CYCLE974, CYCLE994.
Remedy: Check the conditions for measuring.
61331 [Channel %1: ] Block %2: Angle too large, change measuring axis
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Parameter starting angle (_STA) is too large for the specified measuring axis. Alarm is triggered:
CYCLE998.
Remedy: Select another metering axis.
61332 [Channel %1: ] Block %2: Modify tool tip position
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The tool tip is below the measuring probe surface (e.g. for a ring gauge or cube). Alarm is triggered:
CYCLE971, CYLCE972, CYCLE982, E_MT_CAL, E_MT_LEN, E_MT_RAD.
Remedy: Place the tool above the measuring probe surface.
61333 [Channel %1: ] Block %2: Check calibration block number
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered: CYCLE973
Remedy: Parameter _CALNUM is too large, reduce it to a permissible value
For 840D:
- Increase the maximum value of _CVAL[2] in GUD6
For 840D sl:
- Check following machine data: 51601 $MNS_MEA_CAL_EDGE_NUM
61334 [Channel %1: ] Block %2: Check safety area
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered: CYCLE977
Remedy: Check the parameters for the safety area
For 840D: _SZA or _SZO
For 840D sl: XS, YS or ZS
61336 [Channel %1: ] Block %2: Geometry axes do not exist
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: No geometry axes configured. Alarm can be triggered by following measuring cycles: all measuring
cycles.
Remedy: Machine data in MD 20060 must be changed.
61337 [Channel %1: ] Block %2: Check measuring input
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-499