Siemens Sinumerik 840D sl Diagnostic Manual page 227

03/2009
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14824 [Channel %1: ] Block %2 conflict with GWPS
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The functions of constant grinding wheel surface speed GWPS and constant cutting speed G96 S...
have been activated at the same time for a spindle.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14830 [Channel %1: ] Block %2 wrong feed type selected
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: G97 has been programmed in the displayed block although G96 was not (or G97 already) active pre-
viously.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Remove G97 from the displayed block and program the correct feed type (G93, G94, G95 or G96) for
the machining section which follows.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14840 [Channel %1: ] Block %2 incorrect value range for constant cutting speed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The programmed cutting speed is not within the input range
Input range metric: 0.01 to 9 999.99 [m/min]
Input range inch: 0.1 to 99 999.99 [inch/min]
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Program cutting speed under address S within the permissible range of values.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14850 [Channel %1: ] Block %2 changing the reference axis for a constant
cutting speed not allowed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The attempt was made via the SCC[AX] instruction to change the reference
axis for a constant cutting speed.
This is not allowed if the indicated axis is no geometry axis.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
Remedy: Please inform authorized personnel/service.
When programming SCC[AX] indicate a geometry axis known in the channel.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-227