Siemens Sinumerik 840D sl Diagnostic Manual page 305

03/2009
17620 [Channel %1: ] Block %2 approaching fixed point for transformed axis
%3 not possible
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: In the displayed block, an axis is programmed for the fixed point approach (G75) that is involved in the
active transformation. Fixed point approach is not performed with this axis!
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Remove G75 instruction from the part program block or previously deselect transformation with TRA-
FOOF.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
17630 [Channel %1: ] Block %2 referencing for transformed axis %3 not
possible
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: In the displayed block, an axis is programmed for reference point approach (G74) that is involved in
the active transformation. Reference point approach is not performed with this axis!
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Remove G74 instruction, or the machine axes involved in transformation, from the part program block
or previously deselect the transformation with TRAFOOF.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
17640 [Channel %1: ] Block %2 spindle operation for transformed axis %3 not
possible
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: The axis programmed for the spindle operation is involved in the current transformation as geometry
axis. This is not allowed.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: First switch off the transformation function.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
17650 [Channel %1: ] Block %2 machine axis %3 not programmable
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: The machine axis cannot be used in an active transformation. You may be able to program the func-
tion in a different coordinate system. For example, it may be possible to specify the retraction position
in the basic coordinate system or the workpiece coordinate system. The axis identifier is used to select
the coordinate system.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Deactivate the transformation or use another coordinate system.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-305