Siemens Sinumerik 840D sl Diagnostic Manual page 942

Overview of Alarms
SINAMICS-Alarms
233887 <location>Encoder 3 DRIVE-CLiQ (CU): Component fault
Message Component number: %1, fault cause: %2
value:
Drive object: All objects
Reaction: A_INFEED: NONE (OFF1, OFF2)
SERVO: OFF1 (IASC/DCBRAKE, NONE, OFF2, OFF3)
VECTOR: OFF1 (IASC/DCBRAKE, NONE, OFF2, OFF3)
Acknowledge: IMMEDIATELY
Cause: Fault detected on the DRIVE-CLiQ component involved (Sensor Module for encoder 3). Faulty hard-
ware cannot be excluded.
Fault value (r0949, interpret hexadecimal):
yyxx hex: yy = component number, xx = fault cause
xx = 20 hex:
Error in the telegram header.
xx = 23 hex:
Receive error: The telegram buffer memory contains an error.
xx = 42 hex:
Send error: The telegram buffer memory contains an error.
xx = 43 hex:
Send error: The telegram buffer memory contains an error.
xx = 60 hex:
Response received too late during runtime measurement.
xx = 61 hex:
Time taken to exchange characteristic data too long.
Remedy: - check the DRIVE-CLiQ wiring (interrupted cable, contacts, ...).
- check the electrical cabinet design and cable routing for EMC compliance
- if required, use another DRIVE-CLiQ socket (p9904).
- replace the component involved.
233895 <location>Encoder 3 DRIVE-CLiQ (CU): Alternating cyclic data transfer
error
Message Component number: %1, fault cause: %2
value:
Drive object: All objects
Reaction: A_INFEED: NONE (OFF1, OFF2)
SERVO: OFF1 (IASC/DCBRAKE, NONE, OFF2, OFF3)
VECTOR: OFF1 (IASC/DCBRAKE, NONE, OFF2, OFF3)
Acknowledge: IMMEDIATELY
Cause: A DRIVE-CLiQ communication error has occurred from the Sensor Module (encoder 3) involved to the
Control Unit.
Fault value (r0949, interpret hexadecimal):
yyxx hex: yy = component number, xx = fault cause
xx = 0B hex:
Synchronization error during alternating cyclic data transfer.
Remedy: Carry out a POWER ON.
See also: p9915 (DRIVE-CLiQ data transfer error shutdown threshold master)
233896 <location>Encoder 3 DRIVE-CLiQ (CU): Inconsistent component
properties
Message Component number: %1
value:
Drive object: A_INF, B_INF, CU_LINK, S_INF, SERVO, TM15, TM15DI_DO, TM17, TM31, TM41, VECTOR
Reaction: A_INFEED: NONE (OFF1, OFF2)
SERVO: OFF2 (IASC/DCBRAKE, NONE, OFF1, OFF3, STOP1, STOP2)
VECTOR: OFF2 (IASC/DCBRAKE, NONE, OFF1, OFF3, STOP1, STOP2)
Acknowledge: IMMEDIATELY
2-942
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG 2009 All Rights Reserved
03/2009