Siemens Sinumerik 840D sl Diagnostic Manual page 198

Overview of Alarms
NCK alarms
9: Invalid frame chain (the first frame must come before the second frame in the frame chain)
10: Invalid axis name
11: Axis is not a rotary axis
12: Invalid string that cannot be assigned to any of the error types 1 to 11
20: Invalid angle statement (numerical value)
30: Invalid angle of rotation (not an integer multiple of 90 degrees)
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Enter valid string in SD42984 $SC_CUTDIRMOD.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
14197 [Channel %1: ] Block %2 D number and H number programmed
simultaneously
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: A D word and H word have been programmed simultaneously.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14198 [Channel %1: ] Block %2 illegal change of tool direction with tool offset
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: If an offset is active in the tool direction, block change is not possible if this would change the assign-
ment of the offset axes to the channel axes (plane change, tool change, cutter <=> turning tool, geom-
etry axis exchange).
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: - Modify part program.
- Reduce the offset in tool direction to zero.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14199 [Channel %1: ] Block %2 illegal plane change for tool with diameter
component
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: If a tool has a wear or length component which is evaluated as a diameter for the facing axis (bit 0
and/or bit 1 in MD20360 $MC_TOOL_PARAMETER_DEF_MASK is set) and bit 2 of this MD is also
set, this tool may only be used in the plane active on tool selection. A plane change results in an alarm.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Modify part program.
Reset bit 2 in MD20360 $MC_TOOL_PARAMETER_DEF_MASK.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
2-198
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009