Siemens Sinumerik 840D sl Diagnostic Manual page 518

Overview of Alarms
NCK alarms
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61602 [Channel %1: ] Block %2: Tool width incorrectly defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Plunge cutter is larger than the programmed groove width. Alarm triggered by following cycle:
CYCLE93.
Remedy: Check tool or change program.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61603 [Channel %1: ] Block %2: Recess type incorrectly defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Radii/chamfers at the groove base do not match the groove width. Face groove on a contour element
running parallel to the longitudinal axis is not possible. Alarm triggered by following cycle: CYCLE93.
Remedy: Check parameter VARI.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61604 [Channel %1: ] Block %2: Active tool violates programmed contour
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Contour violation in the relief cut elements due to the tool clearance angle of the tool used. Alarm trig-
gered by following cycle: CYCLE95.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Use a different tool or check the contour subroutine.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61605 [Channel %1: ] Block %2: Contour incorrectly programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Illegal relief cut element detected. Alarm triggered by following cycles: CYCLE76, CYCLE77,
CYCLE95.
Remedy: Check contour program.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61606 [Channel %1: ] Block %2: Error during contour preparation
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: An error has been found on conditioning the contour. This alarm is always related to one of NCK
alarms 10930...10934, 15800 or 15810. Alarm triggered by following cycle: CYCLE95.
Remedy: Check contour subroutine.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61607 [Channel %1: ] Block %2: Starting point incorrectly programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The starting point reached before the cycle call does not lie outside the rectangle described by the
contour subroutine. Alarm triggered by following cycle: CYCLE95.
Remedy: Check starting point prior to cycle call.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
2-518
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009