Siemens Sinumerik 840D sl Diagnostic Manual page 115

03/2009
10783 [Channel %1: ] Block %2 tool radius compensation type requires
orientation transformation
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: This alarm occurs, if an attempt is made to activate a tool radius compensation which must enable a
tool orientation change and the _Orientation transformation_ option is not available. This alarm can
only occur if one of the following G code is active in the G code group 22:
- CUT3DC
- CUT3DCC
- CUT3DCCD
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: - Modify part program
- Install "Orientation transformation" option
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
10784 [Channel %1: ] Block %2 illegal tool for tool radius compensation with
constraint surface
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: When activating the tool radius compensation with constraint surface, an illegal tool type is active.
Only cutting tools of the tool types 1 to 399 are admitted with the following exceptions:
- 111 ball end milling cutter
- 155 torus milling cutter
- 156 torus milling cutter
- 157 torus milling cutter
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Use another tool.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
10790 [Channel %1: ] Block %2 plane change during linear programming with
angles
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The active plane was changed between the first and second subblock when programming two straight
lines with angle parameters.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
10791 [Channel %1: ] Block %2 invalid angle during linear programming
Parameters: %1 = Channel number
%2 = Block number, label
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-115