Siemens Sinumerik 840D sl Diagnostic Manual page 455

03/2009
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61004 [Channel %1: ] Block %2: Incorrect configuration of geometry axes
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The geometry-axes sequence is wrong. CYCLE328
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: --
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61005 [Channel %1: ] Block %2: 3rd geometry axis not available
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: With an application on the lathe with no Y-axis in the G18 plane. Alarm triggered by following cycle:
CYCLE86.
Remedy: Check parameter on cycle call.
61006 [Channel %1: ] Block %2: Tool radius too large
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The tool radius is too large for machining. Alarm triggered by following cycles: CYCLE63, CYCLE64,
CYCLE930, CYCLE951, E_CP_CE, E_CP_CO, E_CP_DR, E_PO_CIR, E_PO_REC, F_CP_CE,
F_CP_CO, F_CP_DR, F_PO_CIR, F_PO_REC.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Select a smaller tool.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61007 [Channel %1: ] Block %2: Tool radius too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The tool radius is too small for machining. Alarm triggered by following cycles: CYCLE92, E_CP_CO,
E_SL_CIR, F_CP_CO, F_PARTOF, F_SL_CIR.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Select a larger tool.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61008 [Channel %1: ] Block %2: No tool active
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles:
Remedy: Select a tool.
61009 [Channel %1: ] Block %2: Active tool number = 0
Parameters: %1 = Channel number
%2 = Block number, label
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-455