Siemens Sinumerik 840D sl Diagnostic Manual page 714

Overview of Alarms
SINAMICS-Alarms
202062 <location>Trace: Invalid trigger signal
Message -
value:
Drive object: All objects
Reaction: NONE
Acknowledge: NONE
Cause: - a trigger signal was not specified.
- the specified signal does not exist.
- the specified signal is not a fixed-point signal.
- the specified signal cannot be used as a trigger signal for the trace.
See also: p4711 (Trace trigger signal)
Remedy: Specify a valid trigger signal.
202063 <location>Trace: Invalid data type
Message %1
value:
Drive object: All objects
Reaction: NONE
Acknowledge: NONE
Cause: The specified data type to select a signal using a physical address is invalid.
See also: p4711, p4730, p4731, p4732, p4733
Remedy: Use a valid data type.
202070 <location>Trace: Parameter cannot be changed
Message -
value:
Drive object: All objects
Reaction: NONE
Acknowledge: NONE
Cause: The trace parameter settings cannot be changed when the trace is active.
See also: p4700, p4710, p4711, p4712, p4713, p4714, p4715, p4716, p4720, p4721, p4722, p4730,
p4731, p4732, p4733, p4780, p4781, p4782, p4783, p4789, p4795
Remedy: - stop the trace before parameterization.
- if required, start the trace.
202075 <location>Trace: Pretrigger time too long
Message -
value:
Drive object: All objects
Reaction: NONE
Acknowledge: NONE
Cause: The selected pretrigger time must be shorter than the trace time.
See also: p4721 (Trace recording time), p4722 (Trace trigger delay)
Remedy: Check the pretrigger time setting and change if necessary.
202080 <location>Trace: Delete trace because units changed over
Message -
value:
Drive object: All objects
Reaction: NONE
Acknowledge: IMMEDIATELY
Cause: The trace was deleted due to the fact that the units were changed over or the reference parameters
changed.
Remedy:
2-714
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG 2009 All Rights Reserved
03/2009