Chapter 1 System Management
1.8 Network Management
7
Click the [OK] button.
Setting of the SNMP Agent Community starts.
8
Click the [Done] button to return to the [Network] screen.
1.8.8
Setup SNMP Agent Trap
This function notifies events that occur in the ETERNUS DX to the SNMP Manager by an SNMP Trap.
This function configures the trap destination, the trap version, etc.
Up to ten traps can be specified for each ETERNUS DX.
•
If the "SNMP Function" is disabled, the [Setup SNMP Manager] function cannot be used.
•
When SNMP Manager exists in a different subnetwork from where the ETERNUS DX belongs, specify the IP
address or the network address of SNMP Manager in the "Allowable IP Address" using the procedure in
"1.8.1 Setup Network Environment" (page
For details on the parameters for this function, refer to
For the factory default settings for this function, refer to
The procedure to set the SNMP Agent trap is as follows:
Procedure
1
Click [Setup SNMP Trap] in [Action].
97).
123
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
"A.1.7.8 Setup SNMP Agent Trap" (page
"Appendix B Setup SNMP Agent Trap" (page
End of procedure
716).
981).
P2X0-1270-13ENZ0