Fujitsu ETERNUS DX60 S3 User Manual page 858

Appendix A Parameter List
A.4 Connectivity Management
• Basic Interface
- Reset Scope
Description
Input condition/
Display contents
This item is displayed when the port mode is "CA" or "CA/RA".
- Release Reservation if Chip is Reset
Description
Input condition/
Display contents
This item is displayed when the port mode is "CA" or "CA/RA".
- CmdSN Count
Description
Input condition/
Display contents
This item is displayed when the port mode is "CA" or "CA/RA".
Specify the reset scope of the target port.
Reset scope is the range where the command reset request from the server is
performed, when the target port is connected to multiple servers.
•
I_T_L (I: Initiator, T: Target, L: LUN)
Reset (cancel) the command request from the server that sent the command
reset request.
•
T_L (T: Target, L: LUN)
Reset (cancel) the command request from all of the servers that are connected to
the port.
Select whether to "Enable" or "Disable" the function to release the reserved status of
the volume when the target port (chip) is reset.
•
Enable
•
Disable
Change the number of commands that can be accepted from the host to the target
port at the same time.
It is not necessary to change the setting from "Unlimited" for normal use.
•
Unlimited
•
180
•
100
•
80
•
40
•
20
858
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0