Appendix B Factory Default List
B.1 System Management
■
Setup Subsystem Parameters
Screen
Setup Subsystem Parameters
Setup Host
Setup Disk Drive
Web GUI Settings
■
Setup Encryption Mode
Screen
Encryption Mode Setting
■
Setup SMI-S Environment
For the controller firmware version V10L2x or earlier
Screen
Set SMI-S
Setting item
Thin Provisioning Allocation
Mode
Flexible Write Through
Turbo Mode
Writeback Limit Count
Load Balance
Reject INQUIRY from
Unauthorized Host
Optimize for Advanced Format
SSD
Checkcode Enforcement
Copybackless
Function to Add Host
Use "Add Host Group"
Use "Add Host"
Setting item
Encryption Mode
Setting item
SMI-S
973
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
Default value
TPP balancing
•
For the ETERNUS DX200F
-
When the ETERNUS DX is shipped from the
factory
Enable
-
When the existing controller firmware is
upgraded to V10L30 or later
Disable
•
For storage systems other than the ETERNUS
DX200F
Disable
Disable
512
Enable
Disable
•
When the ETERNUS DX is shipped from the
factory
Enable
•
When the existing controller firmware is
upgraded to V10L30 or later
Disable
Enable
Enable
Selected
Cleared
Default value
Disable
Default value
•
When the ETERNUS DX is shipped to EMEA
region
Enable
•
When the ETERNUS DX is shipped to regions
other than EMEA
Disable
P2X0-1270-13ENZ0