Fujitsu ETERNUS DX60 S3 User Manual page 444

Chapter 4 Connectivity Management
4.3 CA Port Group Management
The main setting items are as follows.
●
Port Settings
• Port
• Connection
• Set Loop ID
• Loop ID
• Transfer Rate
• WWN (Port Name)
• WWN (Node Name)
If some parameters do not satisfy the input conditions, an error screen appears. If this occurs, check
the parameter settings.
3
Click the [Modify] button.
 A confirmation screen appears.
If the Loop ID is changed while a server is operating, reboot the server immediately. If the server is
operated without being rebooted, a warning message may appear or a system failure may occur.
4
Click the [OK] button.
 Modification of the FC port parameters starts.
5
Click the [Done] button to return to the [FC Port] screen.
■ Copying FC Port Parameters
The procedure to copy FC port parameters is as follows:
Procedure
1
Select which FC ports to set the parameters for (multiple selections must be made) and click
[Configure FC Port] in [Action].
Multiple selections can be made from FC ports that have the same "Type" and "Port Mode".
444
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
End of procedure
P2X0-1270-13ENZ0