Fujitsu ETERNUS DX60 S3 User Manual page 411

Chapter 4 Connectivity Management
4.2 Host Group Management
• To change the iSCSI host information, use the [Modify iSCSI Host] function. Refer to
Host" (page 425)
• The host affinity setting can be specified for each iSCSI host. Refer to
338) for details.
For details on the parameters for this function, refer to
For the factory default settings for this function, refer to
The procedure to register an iSCSI host is as follows:
Procedure
1
Click [Add iSCSI Host] in [Action].
2
Add a host in the ETERNUS DX in the following procedures.
■ When registering a host by selecting from the host list
(1)
Click the [Now Connected] tab.
All of the unregistered hosts that are connected to the iSCSI-CAs or the iSCSI-CA/RAs and that can be
recognized by the ETERNUS DX (*1) are displayed. Select the hosts that are to be registered in the
ETERNUS DX and specify the iSCSI host information.
*1:
(2)
Select the host that is to be registered from the iSCSI host list and input the iSCSI host information.
for details.
"Host that is not registered in the ETERNUS DX" indicates that a host with the same iSCSI name, IP
version, and Alias Name as the target host is not registered in the storage system. The host is regarded as
unregistered host even if a host with the same iSCSI name, IP version, Alias Name, and different IP
address is already registered. The obtained "iSCSI Name" and "Port" are displayed.
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
"A.4.2.8 Add iSCSI Host" (page
"Appendix B Add iSCSI Host" (page
411
"4.2.16 Modify iSCSI
"4.1.1 Create Host Affinity" (page
830).
993).
P2X0-1270-13ENZ0