Serverview (Snmp Trap Notification) Setup; Figure 7.36 Send Test E-Mail - Fujitsu Eternus DX60 User Manual

Chapter 7 Setup
7.4 Monitoring Setup
8
7.4.3

ServerView (SNMP Trap Notification) Setup

This section explains how to perform settings to monitor event notification (Trap) by SNMP using
the "ServerView" server monitoring tool.
For details on server settings, refer to the manual that is provided with ServerView.
Refer
Also, for events that are detected by ServerView when monitoring the device, refer to
B Events detected by ServerView" (page
Procedure
1
1-1
1-2
Click the [Send Test E-mail] button to check that an E-mail can be sent to the
specified E-mail destination address.

Figure 7.36 Send Test E-mail

Manual provided with ServerView
Set the network environment of the ETERNUS DX60/DX80/DX90.
When the ETERNUS DX60/DX80/DX90 and ServerView management device are in differ-
ent subnet environments, set the Gateway IP address and destination network address in
the [Setup Network Environment] screen of GUI.
Start GUI.
Click [Setup Network Environment] under the [Network Settings] menu on the [Global
Settings] tab in the GUI screen.
The [Setup Network Environment] screen appears.
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
Copyright 2011 FUJITSU LIMITED
233).
175
End of procedure
"Appendix
P3AM-3042-08ENZ0