Fujitsu ETERNUS DX60 S3 User Manual page 265

Chapter 3 Volume Management
3.1 Create Volume
• When specifying the volume number, select the "Set Value" checkbox and input the volume
number.
• When using the maximum free space in the RAID group to create volumes without specifying the
capacity, select the "Enable" checkbox for "Use all Largest Free Space", and then input the number
of volumes. This setting is available for "Standard" and "SDPV" type volumes.
• For the "Drive Type" field, the type of drive that configures the RAID group is displayed.
If multiple drive types are used in the RAID group, the drive type is displayed as described below:
-
-
-
If an error screen appears under the following conditions, check the parameter settings.
• The "Name" is not entered
• The "Name" does not satisfy the input conditions
• The SDPV capacity that is specified for "Capacity" is not a multiple of the SDPE capacity (1GB/2GB/
4GB)
• The "Enable" checkbox for "Use all Largest Free Space" is cleared and "Capacity" is not entered
• The "Enable" checkbox for "Use all Largest Free Space" is selected and the capacity of the created
volume is 23MB or less
• The "Enable" checkbox for "Use all Largest Free Space" is selected and the capacity of the created
volume is larger than the maximum capacity
• The "Set Value" checkbox is selected and "Volume No." is not entered
• The input value of "Volume No." exceeds the settable range
• The specified "Volume No." is already used
• The "Volume No." is specified and total number of values that are specified to "Number of Volumes"
is not "1"
• The number of volumes that is specified for "Number of Volumes" exceeds the maximum number
of volumes that can be created
• Free space in the RAID group is insufficient
• LDE is being performed in the target RAID group
4
Click the [Create] button.
 A confirmation screen appears.
5
Click the [OK] button.
 Volume creation starts.
6
Click the [Done] button to return to the [Volume] screen.
If only "Online" type drives are used or if both "Online" and "Nearline" type drives are used,
"Online" is displayed.
If only "Online SED" type drives are used or if both "Online SED" and "Nearline SED" type drives
are used, "Online SED" is displayed.
If a single SSD type (SSD-M/SSD) is used or if multiple SSD types (SSD-M/SSD) are used, "SSD" is
displayed.
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
265
End of procedure
P2X0-1270-13ENZ0