Frequently Used Procedures; Connecting And Disconnecting The 12 Vdc Battery - Toro Reelmaster 5010-H Diagnostic Manual

Frequently Used Procedures

Connecting and Disconnecting the 12 Vdc Battery

CAUTION
Before installing, removing, or servicing components in the 12 Vdc system (e.g., starter,
alternator, control arm components), disconnect the 12 Vdc battery. This prevents unexpected
operation of 12 Vdc system components.
1. Park the machine on a level surface and lower the cutting units.
2. Shut off the engine, apply the parking brake, and remove the key from the ignition switch.
3. At the back of the machine, release the screen latch and pivot the screen to the open position
1. Screen
Figure 3
2. Screen latch
17
(Figure 3).
g032654