Toro Reelmaster 5010-H Diagnostic Manual page 85

7. Press the right button as needed to display the Inputs menu.
Note:
On the Inputs menu, the Key Start item appears. Because the ignition key is in the O
the Key Start item status reads O
When the ignition key is rotated to the S
start it.
8. Turn the ignition key to the S
then release the key (R
status of the Key Start item changes from O
(R position).
UN
9. Turn the ignition key to the O
1. Indicator light
2. Right button: press it to open a menu where a right arrow in
the display indicates additional content.
Pass The engine start output signal passed the InfoCenter testing. Go to Step 4.
Service (page 22)
Fail The engine start output signal failed the InfoCenter testing. Go to Step 3.
Step 3: Test the start relay.
1. Open the engine hood and locate the start relay behind the operator's seat on the right side of the
machine. See Figure 58
.
FF
TART
position, and hold the key in the S
TART
position). If the engine start signal from the TEC-5002 is working correctly, the
UN
FF
position.
FF
and follow the steps listed.
and Figure 59.
position, the starter engages the engine and attempts to
to O , and then back to O
N
Figure 57
3. Middle button: press it to scroll down menus.
4. Left button (Menu Access/Back Button): press it to access the
InfoCenter menus. You can use it to back out of any menu
you are currently using.
85
position for 5 seconds, and
TART
when the key is released
FF
Returning the Machine to
position,
N
g020650