Toro Reelmaster 5010-H Diagnostic Manual page 431

Location Harness
1 Main
2
1 Main
2
Pass The CAN bus wiring tests passed. Go to Step 3.
Fail
One or more of the CAN bus wiring tests failed. Repair or replace the worn or damaged parts. Go to
Returning the Machine to Service (page 22)
Step 3: Remove the motor/generator assembly from the machine.
1. Operator's seat
2. Motor/generator connector P37
Remove the motor/generator assembly from the machine. Refer to Chapter 5 of the 5010-H Service Manual.
See Figure 167.
Pin
Connector
P37 5
Chassis ground
P37 6
Chassis ground
Wire Expected
Color Reading
Yellow
Open
(infinite)
Green
Open
(infinite)
and follow the steps listed.
Figure 167
3. Motor/generator controller (mounted to motor/generator
assembly)
431
Connector Graphic
g035728