Toro Reelmaster 5010-H Diagnostic Manual page 58

Step 2: Use the InfoCenter to test the ignition switch.
1. Indicator light
2. Right button: press it to open a menu where a right arrow
indicates additional content.
Perform the following steps to test the ignition switch using the InfoCenter:
1. Turn the ignition key to the O
2. On the InfoCenter, press the left button as needed to display the Main Menu.
3. Press the center button as needed to highlight the Diagnostics item.
4. Press the right button as needed to display the Diagnostics menu.
5. Press the center button as needed to highlight the Engine Start item.
6. Press the right button as needed to display the Engine Start menu.
7. The Inputs item is selected when the Engine Start menu appears. Press the right button once to display
the Inputs menu.
8. On the Inputs menu, the Key Start item is displayed. Because the ignition key is in the O
the Key Start item status reads O
Note:
When the ignition key is rotated to the S
attempts to start it.
9. Turn the ignition key to the S
the ignition switch is working correctly, the Key Start item status changes from O
back to O when you release the key.
FF
10. Turn the ignition key to the O
Pass The ignition switch passed the InfoCenter testing. Go to
and follow the steps listed.
Fail
The ignition switch failed the InfoCenter testing. Go to Step 3.
Step 3: Test the ignition switch manually.
Refer to the 5010-H Service Manual, Chapter 5, Component Testing section, Ignition Switch for instructions on
how to manually test the switch.
Pass The ignition switch passed the manual testing. Go to Step 4.
Fail The ignition switch failed the manual testing. Repair or replace worn or damaged parts as required.
Go to Returning the Machine to Service (page 22)
Figure 36
3. Middle button: press it to scroll down menus.
4. Left button (Menu Access/Back Button): press it to access the
position.
N
.
FF
TART
position and hold it there for 5 seconds, and then release the key. If
TART
position.
FF
58
InfoCenter menus. You can use it to back out of any menu
you are currently using.
position, the starter engages the engine and
Returning the Machine to Service (page 22)
and follow the steps listed.
g020650
position,
N
to O and then
FF N