Toro Reelmaster 5010-H Diagnostic Manual page 414

4. Plug in the 48 Vdc battery disconnect. Refer to
(page 19).
5. Operate the machine.
The fault moves to the
new position.
The fault stopped
repeating.
Step 6: Use Toro DIAG to program the replacement cutting reel motor.
1. Remove the access panel from the outer cover of the control arm.
2. Connect a PC with Toro DIAG software to the machine via a Toro DIAG Cable (Part No. 115-1944). Refer
to Toro DIAG - Quick Start (page
3. Use the Toro DIAG software to reprogram the machine in accordance with Toro DIAG User's Guide. The
replacement cutting reel motor is programmed during the reprogramming of the machine.
4. Disconnect the Toro DIAG cable from the machine.
5. Install the access panel onto the outer cover of the control arm.
6. Go to Returning the Machine to Service (page 22)
Component Location and Electrical Connections
Cutting reel motor 2 is located in the rear, left position. There are 2 electrical connections to the cutting reel
motor: P38 (4 wire) and P39 (2 wire).
Connecting and Disconnecting the 48 Vdc Battery System
If the fault follows the cutting reel motor to the new cutting unit, replace the
cutting reel motor. Go to Step 6.
If the fault no longer repeats, note the position change of the cutting reel motor
in the maintenance records for the machine. Should the fault repeat in the
future, troubleshooting may be resumed where you left off. Go to
Machine to Service (page 22)
24).
and follow the steps listed.
and follow the steps listed.
414
Returning the