Fault 33: Unknown Motor/Generator Fault - Toro Reelmaster 5010-H Diagnostic Manual

Fault 33: Unknown Motor/Generator Fault

InfoCenter Display:
Fault Description
An unknown motor/generator fault has occurred. An error in the fault reference table exists in the TEC-5002
software.
Circuit Description
All fault reference tables are stored in the non-volatile memory of the TEC-5002.
Conditions for Setting the Fault
Only an error in the TEC-5002 software can cause the TEC-5002 to set this fault.
Recommended Service Actions
Step 1: Verify that the fault repeats.
1. Clear the system faults from the InfoCenter. Refer to
2. Operate the machine.
Pass The fault did not repeat. Go to
Note:
If the fault does not repeat, an isolated event has occurred.
Fail The fault repeated. Contact the Toro Technical Assistance Center for additional guidance.
Note:
You must fix this software fault; accomplish the TEC-5002 software repair with direct
assistance from Toro.
_____FAULT #33_____
Unknown
Clearing Faults from the InfoCenter (page
Returning the Machine to Service (page 22)
113
Fault
21).
and follow the steps listed.