Clearing Faults From The Infocenter - Toro Reelmaster 5010-H Diagnostic Manual

1. Fault indicator light
If an electrical fault occurs, the InfoCenter fault indicator light flashes
description appears on the display.
•
Faults that are currently happening are called active faults. As soon as a fault occurs, information about
that fault is displayed on the InfoCenter. Faults remain active on the screen until you clear them or until the
condition that created the fault no longer exists.
•
Use the InfoCenter Faults screen to see a list of faults that occurred before the most recent starting of the
machine. The Faults screen lists all of the machine faults that have occurred since the InfoCenter fault log
was last cleared.

Clearing Faults from the InfoCenter

Note:
You can clear system faults from the InfoCenter if you have the PIN number for access. The complete
fault history is retained in the TEC-5002 memory and can be viewed via Toro DIAG software.
Entering the PIN code
1. From the Main menu, press the left button as needed to access the Settings menu.
2. Press the middle (down) button as needed to highlight Protected Menus.
3. Press the right button to select Protected Menus.
4. Press the right button to enter the PIN screen.
5. Press the middle button to change the numeric values, and the right button to select each digit.
6. When the PIN entry is complete, press the right button to enter the code.
7. If the code entry is correct, a check-mark icon appears at the bottom/center of the InfoCenter display
screen.
8. Press the middle button once to return to the Main menu. If the PIN has been entered correctly, the
InfoCenter screen displays "PIN" in the upper right corner of the screen.
Note:
The PIN stays active until the ignition is turned O
again after the machine has been turned off, you will need to reenter the PIN.
Clearing faults after entering the PIN
Figure 8
(Figure
. If you need to access the Protected menus
FF
21
8) and a fault code with a
g032657