Fault 57: Mismatched Cutting Unit Sizes - Toro Reelmaster 5010-H Diagnostic Manual

Fault 57: Mismatched Cutting Unit Sizes

InfoCenter Display:
Fault Description
The cutting unit sizes (5-inch and 7-inch diameter reel units) are mixed.
Circuit Description
The TEC-5002 can detect whether a 5-inch or 7-inch reel cutting unit is installed. All cutting unit sizes must
match in cutting units 1 through 5 before the machine functions normally.
Conditions for Setting the Fault
The TEC-5002 detects that all of the cutting units are not the same reel diameter.
Recommended Service Actions
Step 1: Verify that the fault repeats.
1. Clear the system faults from the InfoCenter. Refer to
2. Operate the machine.
Pass The fault did not repeat. Go to
Note:
If the fault does not repeat, an isolated event has occurred.
Fail The fault repeated. Go to Step 2.
Step 2: Verify that all 5 cutting units have the same diameter reel.
1. Visually inspect all 5 cutting units and verify that the machine is equipped with cutting units that are the
same size (either 5-inch or 7-inch diameter). Refer to
_____FAULT #57_____
CU Size Incompatible
Clearing Faults from the InfoCenter (page
Returning the Machine to Service (page 22)
Figure 121
206
and follow the steps listed.
for the locations of the cutting units.
21).