Fault 34: Unknown Master Controller Fault - Toro Reelmaster 5010-H Diagnostic Manual

Fault 34: Unknown Master Controller Fault

InfoCenter Display:
Fault Description
An unknown TEC-5002 controller fault has occurred. There is an error in the fault reference table of the
TEC-5002 (master) controller.
Circuit Description
All fault reference tables are stored in the non-volatile memory of the TEC-5002 controller.
Conditions for Setting the Fault
Only an error in the TEC-5002 software can cause the TEC-5002 to set this fault.
Recommended Service Actions
Step 1: Verify that the fault repeats.
1. Clear the system faults from the InfoCenter. Refer to
2. Operate the machine.
Pass The fault did not repeat. Go to
Note:
If the fault does not repeat, an isolated event has occurred.
Fail The fault repeated. Contact the Toro Technical Assistance Center for additional guidance.
Note:
You must fix this software fault; accomplish the TEC-5002 software repair with direct
assistance from Toro.
_____FAULT #34_____
Unknown Master Fault
Clearing Faults from the InfoCenter (page
Returning the Machine to Service (page 22)
114
21).
and follow the steps listed.