Toro Reelmaster 5010-H Diagnostic Manual page 78

1. Location ID module
6. Using a multimeter, measure resistances between module connector pins as follows:
ID Module Connector Pins
Note:
Do not remove the cover of the location ID module. There are no replaceable parts under the cover.
Pass The location ID module tested good. Go to Step 3.
Fail
The location ID module tested bad. Replace the location ID module. Go to
Service (page 22)
Step 3: Test the location ID module wiring in the main harness.
1. Install the location ID module.
2. Use a multimeter to test the following pairs of locations from cutting reel motor cable connectors:
Note:
The expected reading includes the location ID module value and the wiring.
Location Harness
1 Main
2 Main
A and F
B and F
C and F
D and F
E and F
and follow the steps listed.
Connector Pin
P46 2
P47 2
Figure 53
2. ID module connector
Wire Expected
Color Reading
Blue
1.6k ohms
Black
(48V
Ground)
78
Resistance
15k ohms
10k ohms
6.2k ohms
3.9k ohms
1.6k ohms
Returning the Machine to
Connector Graphic
g036165