Toro Diag Software; Acronyms - Toro Reelmaster 5010-H Diagnostic Manual

Toro DIAG Software

Download the Toro DIAG software from the Toro Dealer and Distributor Portal and then install the software on a
computer. This software is intended to assist you with troubleshooting electrical issues on Toro machines that
use a Toro electronic controller (TEC).
The features and benefits of the Toro DIAG software include the following:
•
The software uses a USB to CAN connection via a Toro DIAG USB/CAN Cable (Toro Part No. 115-1944).
•
You can monitor the controller system in the entire machine.
•
The software is a Windows-based application.
•
Software updates to Toro DIAG are sent automatically.
•
You can review fault codes and their descriptions.
•
You can see machine counters and timers.
•
You can download a machine counters and timers file for uploading into a replacement TEC-5002 controller.
•
You can easily reprogram the machine.
•
You can see the inputs and the outputs.
•
You can see the current status of each of the various controllers.
The Toro DIAG User's Guide
(Site login is required.)
The Toro DIAG software
login is required.)

Acronyms

Acronym
AGM
CAN
CRM
CU
DPA
ECT
FET
IPE
M/G
psi
SV (SV1, SV2, SV3)
SVRV (SV4)
TEC
(Part No. 12194SL) is available through the Toro Dealer and Distributor Portal.
is available for downloading through the Toro Dealer and Distributor Portal. (Site
Definition
Absorbed glass mat (battery)
Controller area network
Cutting reel motor (the motor that drives the cutting reel)
Cutting unit
Dual point adjust
Engine coolant temperature
Field-effect transistor
Input pull-up enable
Motor/generator
pounds/square inch
Solenoid valve
Solenoid valve, relief valve
Toro electronic controller
9