Toro Reelmaster 5010-H Diagnostic Manual page 59

Step 4: Test the ignition switch circuit wiring.
1. Locate the ignition switch in the control arm
1. Connector P02
2. Use a multimeter to test the resistance between the following pair of locations:
Location Harness
1 Seat
2 Seat
3. Repair or replace worn or damaged wiring as required. Go to
22) and follow the steps listed.
(Figure
Figure 37
Connector Pin
P02 A
P02 C
37).
Wire Expected
Color Reading
Violet/
Black
2k to 3k
ohms
Yellow
Returning the Machine to Service (page
59
Connector Graphic
g033102