Cisco ONS 15454 Series Procedure Manual page 93

Chapter 1 Install the Cisco ONS 15454 Shelf Assembly
Tools Needed (ANSI)
The following tools are needed to install an ONS 15454 ANSI:
•
•
•
•
•
•
•
•
Test Equipment (ANSI)
The following test equipment is needed to install an ONS 15454 ANSI:
•
•
•
Required Tools and Equipment (ETSI)
You need the following tools and equipment to install and test the ONS 15454 ETSI shelf assembly.
Cisco-Supplied Equipment (ETSI)
These materials are required for installation and are supplied with the ONS 15454 ETSI. The shipped
quantity of each item is in parentheses.
•
•
•
•
•
•
•
•
•
•
•
78-19286-01
#2 Phillips Dynamometric screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
Wire wrapper
Wire cutters
Wire strippers
Crimp tool
BNC insertion tool
Voltmeter
Optical power meter (for use with fiber optics only)
Bit error rate (BER) tester, DS-1 and DS-3
Double-hole grounding lug for ground connection with a wire receptacle to accommodate the
recommended 13.3 mm² (#6 AWG) multistrand copper wire (1)
M4 x 8 mm pan-head Phillips screws (2)
M6 x 20 mm socket set screws (2)
M6 x 20 mm pan-head Phillips screws (8)
Tie wraps 0.125-inch (3.2 mm) W x 6.0-inch (152 mm) L (24)
ESD wrist strap (disposable) (1)
Pinned hex (Allen) key for front door (1)
Hex key 3-mm long arm (1)
Bottom brackets for the fan-tray air filter
Cable assembly, Ethernet, RJ-45 (1)
Power cable (from fuse and alarm panel to MIC-A/P and MIC-C/T/P) (2)
Required Tools and Equipment (ETSI)
Cisco ONS 15454 DWDM Procedure Guide, Release 9.2
1-5