Cisco ONS 15454 Series Procedure Manual page 169
Dwdm
Hide thumbs
Also See for ONS 15454 Series:
- Procedure manual (850 pages) ,
- Reference manual (728 pages) ,
- Troubleshooting manual (558 pages)
Table of Contents
Advertisement
Chapter 1
Install the Cisco ONS 15454 Shelf Assembly
•
Repeat Steps 1 through
Step 5
Return to your originating procedure (NTP).
Step 6
NTP-G301 Connect the ONS 15454 Multishelf Node and
Subtending Shelves to an MS-ISC-100T Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
To connect the MS-ISC-100T cards to the node controller shelf and set up protection, complete the
Step 1
following substeps (see
refer to the "Common Control Cards" chapter in the Cisco ONS 15454 DWDM Reference Manual.
a.
b.
c.
78-19286-01
The green ACT or ACT/STBY LED turns on. The SF LED can persist until all card ports connect
to their far end counterparts and a signal is present.
If the red FAIL LED does not turn on, check the power.
Note
If you insert a card into a slot provisioned for a different card, all LEDs turn off.
Note
4
for the redundant MS-ISC-100T card.
Use this procedure to connect a multishelf node and subtending shelves to
two MS-ISC-100T cards.
5.9 in. (0.15 m) CAT-5 LAN cable (2)
19.69 in. (0.5 m) CAT-5 LAN cable (1)
Cross-over (CAT-5) LAN cables (2 for each subtending shelf)
EAP cables (2)
NTP-G15 Install the Common Control Cards, page 1-74
DLP-G371 Install the Ethernet Adapter Panel, page 1-69
(Optional)
As needed
Onsite
None
Figure
Using the 5.9 in. (0.15 m) CAT-5 LAN cable, plug one connector into the NC port of the
MS-ISC-100T card located on the left side of the node controller shelf (Slots 1 to 6) and plug the
other connector into the front panel (RJ-45 connector) of the TCC2/TCC2P/TCC3 card in Slot 7.
Using the 5.9 in. (0.15 m) CAT-5 LAN cable, plug one connector into the NC port of the
MS-ISC-100T card located on the right side of the node controller shelf (Slots 12 to 17) and the
other end into the front panel (RJ-45 connector) of the TCC2/TCC2P/TCC3 card in Slot 11.
Using the 19.69 in. (0.5 m) CAT-5 LAN cable, plug one connector into the PRT port of the
MS-ISC-100T card located on the left side of the node controller shelf (Slots 1 to 6) and plug the
other connector into the PRT port of the MS-ISC-100T card located on the right side of the node
controller shelf (Slots 12 to 17).
DLP-G264 Enable Node Security Mode, page 5-26
1-32). For more information on MS-ISC-100T card port assignments,
Cisco ONS 15454 DWDM Procedure Guide, Release 9.2
Required Tools and Equipment (ETSI)
1-81
Advertisement
Table of Contents
