Cisco ONS 15454 Series Procedure Manual page 163

Chapter 1 Install the Cisco ONS 15454 Shelf Assembly
Always use the supplied ESD wristband when working with a powered ONS 15454. For detailed
Caution
instructions on how to wear the ESD wristband, refer to the
and Grounding
If protective clips are installed on the backplane connectors of the cards, remove the clips before
Note
installing the cards.
Note If you install a card incorrectly, the FAIL LED flashes continuously.
Step 1 (Cisco ONS 15454 only) Complete the
page
Note
(Cisco ONS 15454 only) Complete the
Step 2
necessary.
Step 3 (Cisco ONS 15454 only) Complete the
if necessary.
Stop. You have completed this procedure.
DLP-G33 Install the TCC2, TCC2P, or TCC3 Card
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Caution Do not remove a TCC2/TCC2P/TCC3 card during the software transfer process, which is indicated by
alternate flashing FAIL and ACT/STBY LEDs. Removing a TCC2/TCC2P/TCC3 during the software
transfer process will corrupt the system memory.
Note Allow each card to boot completely before installing the next card.
78-19286-01
Guide.
1-75.
If you install the wrong card in a slot, see the
Replace DWDM Cards" procedure on page
This task installs redundant TCC2/TCC2P/TCC3 cards. The first card you
install in the ONS 15454 must be a TCC2/TCC2P/TCC3 card, and it must
initialize before you install any cross-connect or traffic cards.
Cross-connect cards are only required in hybrid nodes.
Two TCC2/TCC2P/TCC3 cards
Required
Onsite
None
Cisco ONS Electrostatic Discharge (ESD)
"DLP-G33 Install the TCC2, TCC2P, or TCC3 Card" task on
"NTP-G107 Remove Permanently or Remove and
14-2.
"DLP-G34 Install the AIC-I Card" task on page
"DLP-G309 Install the MS-ISC-100T Card" task on page
Cisco ONS 15454 DWDM Procedure Guide, Release 9.2
Required Tools and Equipment (ETSI)
1-79, if
1-80,
1-75