Cisco ONS 15454 Series Procedure Manual page 63

DLP-G54 Create a New User on a Single Node
DLP-G55 Create a New User on Multiple Nodes
DLP-G56 Provision IP Settings
DLP-G439 Provision the Designated SOCKS Servers
DLP-G57 Set the IP Address, Default Router, and Network Mask Using the LCD
DLP-G264 Enable Node Security Mode
DLP-G58 Create a Static Route
DLP-G59 Set Up or Change Open Shortest Path First Protocol
DLP-G60 Set Up or Change Routing Information Protocol
DLP-G61 Provision the IIOP Listener Port on the ONS 15454
DLP-G62 Provision the IIOP Listener Port on the CTC Computer
DLP-G283 Provision OSI Routing Mode
DLP-G284 Provision the TARP Operating Parameters
DLP-G285 Add a Static TID-to-NSAP Entry to the TARP Data Cache
DLP-G287 Add a TARP Manual Adjacency Table Entry
DLP-G288 Provision OSI Routers
DLP-G289 Provision Additional Manual Area Addresses
DLP-G290 Enable the OSI Subnet on the LAN Interface
DLP-G291 Create an IP-Over-CLNS Tunnel
DLP-G351 Delete a Card in CTC
DLP-G353 Preprovision a Slot
DLP-G541 Add an ANS Parameter
DLP-G542 Delete an ANS Parameter
DLP-G348 Use the Cisco TransportPlanner Shelf Layout Report
DLP-G63 Install an SFP or XFP
DLP-G273 Preprovision an SFP or XFP Slot
DLP-G64 Remove an SFP or XFP
DLP-G543 Add Passive Units Manually
DLP-G544 Delete a Passive Unit
DLP-G349 Use the Cisco TransportPlanner Internal Connections Report
DLP-G315 Install Fiber-Optic Cables From the 32WSS/32DMX and 32MUX-O/32DMX-O Cards to the Standard
DLP-G316 Install Fiber-Optic Cables from TXP, MXP, GE_XP, 10GE_XP, GE_XPE, 10GE_XPE, ADM-10G, or
DLP-G356 Install Fiber-Optic Cables from the 32WSS/32DMX and 32MUX-O/32DMX-O Cards to the Deep
78-19286-01
5-13
5-19
5-26
5-28
5-38
5-42
5-45
5-52
5-54
5-58
5-58
5-67
5-68
5-69
5-72
5-72
Patch Panel Tray
5-80
OTU2_XP Cards to the Standard Patch Panel Tray
Patch Panel Tray
5-85
5-14
5-22
5-29
5-31
5-35
5-36
5-39
5-41
5-42
5-43
5-44
5-62
5-75
5-84
Cisco ONS 15454 DWDM Procedure Guide, Release 9.2
Contents
5-24
lxiii