Cisco ONS 15454 Series Procedure Manual page 168

Required Tools and Equipment (ETSI)
Return to your originating procedure (NTP).
Step 5
DLP-G309 Install the MS-ISC-100T Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note When installing cards, allow each card to boot completely before installing the next card.
Note The MS-ISC-100T is not supported in a subtended shelf.
Open the latches/ejectors on the card.
Step 1
Use the latches/ejectors to firmly slide the card along the guide rails into the appropriate slot in the node
Step 2
controller shelf until the card plugs into the receptacle at the back of the slot. The card can be installed
in any slot from Slot 1 to 6 or 12 to 17. Cisco recommends that you install the MS-ISC-100T cards in
Slot 6 and Slot 12.
Verify that the card is inserted correctly and close the latches/ejectors on the card.
Step 3
Note
Step 4 Verify the LED activity:
•
•
•
•
Cisco ONS 15454 DWDM Procedure Guide, Release 9.2
1-80
Note If the red FAIL LED is on continuously or the LEDs act erratically, the card is not installed
properly. Remove the card and repeat Steps
This task installs redundant MS-ISC-100T cards. The MS-ISC-100T card
is required for a multishelf node configuration. It provides LAN
redundancy on the node controller shelf. An alternative to using the
MS-ISC-100T card is the Cisco Catalyst 2950, although Cisco recommends
using the MS-ISC-100T. For more information on the Catalyst 2950
installation, refer to the Catalyst 2950 product documentation.
MS-ISC-100T card (2)
DLP-G33 Install the TCC2, TCC2P, or TCC3 Card, page 1-75
As needed
Onsite
None
It is possible to close the latches/ejectors when the card is not completely plugged into the
backplane. Ensure that you cannot insert the card any further.
The red FAIL LED blinks for 35 to 45 seconds.
The red FAIL LED turns on for 15 to 20 seconds.
The red FAIL LED blinks for approximately 3 minutes.
The red FAIL LED turns on for approximately 6 minutes.
Chapter 1 Install the Cisco ONS 15454 Shelf Assembly
1 to 4.
78-19286-01