Figure 1-28 Backplane Attachment For The Rear Cover - Cisco ONS 15454 Series Procedure Manual

Chapter 1 Install the Cisco ONS 15454 Shelf Assembly
NTP-G13 Install the Rear Cover (ANSI Only)
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Locate the three screws that run vertically along on each side of the backplane
Figure 1-28
Tip
Loosen the top and bottom screws on one edge of the backplane to provide room to slide the mounting
Step 2
brackets into place using the U-shaped screw slots on each end.
Step 3 Slide one of the mounting brackets into place and tighten the screws.
Repeat Steps
Step 4
Attach the cover by hanging it from the mounting screws on the back of the mounting brackets and
Step 5
pulling it down until it fits snugly into place.
78-19286-01
The following procedure explains how to install the rear cover on an
ONS 15454 ANSI shelf.
#2 Phillips Dynamometric screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
NTP-G5 Remove the Backplane Covers (ANSI Only), page 1-29
Required
Onsite
None
Backplane Attachment for the Rear Cover
Screw locations
for attaching the
rear cover
Only six screws (three on each side) line up with the screw slots on the mounting brackets,
making the screws easy to locate.
2 and 3 for the second mounting bracket.
Required Tools and Equipment (ETSI)
Cisco ONS 15454 DWDM Procedure Guide, Release 9.2
(Figure 1-28).
1-65