Cisco ONS 15454 Series Procedure Manual page 129

Chapter 1 Install the Cisco ONS 15454 Shelf Assembly
NTP-G8 Install the Fan-Tray Assembly
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Do not operate an ONS 15454 without a fan-tray air filter. A fan-tray air filter is mandatory, except for
Caution
ONS 15454 ANSI applications in an outside plant cabinet.
You must place the edge of the air filter flush against the front of the fan-tray assembly compartment
Caution
when installing the fan tray on top of the filter. Failure to do so could result in damage to the filter, the
fan tray, or both.
Caution Do not force a fan-tray assembly into place. Doing so can damage the connectors on the fan tray and/or
the connectors on the back panel of the shelf assembly.
15454-CC-FTA is compatible with Software Release 2.2.2 and greater and shelf assemblies
Note
15454-SA-HD and 15454-SA-ANSI. 15454E-CC-FTA is compatible with Software Release 4.0 and
greater and shelf assembly 15454-SA-ETSI.
Caution If you install the air filter below 15454E-CC-FTA or 15454-CC-FTA, only filters with part numbers
700-23193-01 and 700-23194-01 can be used in this configuration.
Error messages appear on the TCC2/TCC2P/TCC3 card, the fan-tray LED, and in Cisco Transport
Note
Controller (CTC) when the fan-tray assembly is removed from the shelf or when one fan is not working.
Note If you are installing the ONS 15454 in an outside plant cabinet, remove the air filter to provide maximum
cooling capabilities and to comply with Telcordia GR-487-CORE.
To install the fan-tray assembly, it is not necessary to move any of the fiber-storage facilities.
Note
78-19286-01
This procedure installs the fan-tray assembly.
#2 Phillips Dynamometric screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
NTP-G3 Open and Remove the Front Door, page 1-22
NTP-G7 Install the Power and Ground, page 1-33
Required
Onsite
None
Cisco ONS 15454 DWDM Procedure Guide, Release 9.2
Required Tools and Equipment (ETSI)
1-41