Cisco ONS 15454 Series Procedure Manual page 117

Chapter 1 Install the Cisco ONS 15454 Shelf Assembly
NTP-G5 Remove the Backplane Covers (ANSI Only)
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Complete the
Step 2 Complete the
Step 3 Continue with the
Stop. You have completed this procedure.
DLP-G13 Remove the Lower Backplane Cover
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Unscrew the five retaining screws that hold the cover in place
Step 1
78-19286-01
This procedure describes how to access the ONS 15454 ANSI backplane
by removing the covers. The backplane has two sheet metal covers (one
on either side) and a lower backplane cover at the bottom.
#2 Phillips Dynamometric screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
NTP-G306 Install the ONS 15454 Shelf Assembly, page 1-8
NTP-G3 Open and Remove the Front Door, page 1-22
Required
Onsite
None
"DLP-G13 Remove the Lower Backplane Cover" task on page
"DLP-G14 Remove the Backplane Sheet Metal Cover" task on page
"NTP-G7 Install the Power and Ground" procedure on page
This task removes the lower backplane cover of the ONS 15454 ANSI shelf
assembly.
#2 Phillips Dynamometric screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
Required
Onsite
None
Required Tools and Equipment (ETSI)
(Figure 1-14).
Cisco ONS 15454 DWDM Procedure Guide, Release 9.2
1-29.
1-30.
1-33.
1-29