Cisco ONS 15454 Series Procedure Manual page 146

Required Tools and Equipment (ETSI)
Table 1-7
Pin Field
LAN 1
Connecting to DTE (a
PC/workstation or router)
1. The ONS 15454 ANSI is a DCE.
Note
Step 2 Return to your originating procedure (NTP).
DLP-G26 Install the TL1 Craft Interface Wires (ANSI Only)
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note Rather than using the craft pins, you can use a LAN cable connected to the TCC2/TCC2P/TCC3
EIA/TIA-232 port to access a TL1 craft interface.
Step 1 Using #22 or #24 AWG (0.51 mm² or 0.64 mm²) wire, wrap the craft interface wires on the appropriate
wire-wrap pins according to local site practice.
Wrap the ground shield of the craft interface cable to the frame-ground pin.
Step 2
Wrap the ground wire of your computer cable to pin A3 on the craft pin field.
assignments for the CRAFT pin field.
Cisco ONS 15454 DWDM Procedure Guide, Release 9.2
1-58
LAN Pin Assignments for the ONS 15454 ANSI Shelf (continued)
Backplane Pins
B1
A1
B2
A2
The TCC2/TCC2P/TCC3 does not support Ethernet polarity detection. If your Ethernet
connection has incorrect polarity (this can only occur with cables that have the receive wire pairs
flipped), a LAN Connection Polarity Reversed (LAN-POL-REV) condition is raised. This
condition usually occurs during an upgrade or initial node deployment. To correct the situation,
ensure that your Ethernet cable has the correct mapping of the wire-wrap pins.
This task installs the TL1 craft interface on the ONS 15454 ANSI shelf
using the craft backplane pins. You can also use a LAN cable connected to
the TCC2/TCC2P/TCC3 EIA/TIA-232 port to access a TL1 craft interface.
Wire wrapper
#22 or #24 AWG (0.51 mm² or 0.64 mm²) alarm wires
NTP-G5 Remove the Backplane Covers (ANSI Only), page 1-29
As needed
Onsite
None
Chapter 1 Install the Cisco ONS 15454 Shelf Assembly
RJ-45 Pins Function/Color
1 RX+ white/green
2 RX– green
3 TX+ white/orange
6 TX– orange
Table 1-8 shows the pin
78-19286-01