Cisco ONS 15454 Series Procedure Manual page 175

Chapter 1 Install the Cisco ONS 15454 Shelf Assembly
(Router(config)# no ip route-cache
(Router(config)# shutdown
(Router(config)# crc 32
(Router(config)# interface POS1
(Router(config)# no ip address
(Router(config)# no ip route-cache
(Router(config)# shutdown
(Router(config)# crc 32
(Router(config)# ip classless
(Router(config)# no ip http server
Stop. You have completed this procedure.
NTP-G16 G307 Perform the ONS 15454 Shelf Installation
Acceptance Test
Purpose
Tools/Equipment
Prerequisite Procedures Applicable procedures in
Required/As Needed
Onsite/Remote
Security Level
Step 1 If you installed an ONS 15454 ETSI shelf, complete
procedure was completed.
Table 1-12
Description
NTP-G305 Unpack and Inspect the ONS 15454 Shelf Assembly, page 1-7
NTP-G306 Install the ONS 15454 Shelf Assembly, page 1-8
NTP-G3 Open and Remove the Front Door, page 1-22
NTP-G4 Open and Remove the FMEC Cover (ETSI Only), page 1-26
NTP-G6 Install the MIC-A/P and MIC-T/C/P FMECs (ETSI Only), page 1-31
NTP-G7 Install the Power and Ground, page 1-33
NTP-G8 Install the Fan-Tray Assembly, page 1-41
NTP-G10 Attach Wires to Alarm, Timing, LAN, and Craft Pin Connections,
page 1-48
NTP-G12 Install and Close the FMEC Cover (ETSI Only), page 1-63
NTP-G14 Install DWDM Equipment, page 1-66
78-19286-01
Use this procedure to perform a shelf installation acceptance test for the
ONS 15454 ETSI or ONS 15454 ANSI.
Voltmeter
Assembly"
Required
Onsite
None
ONS 15454 ETSI Shelf Installation Task Summary
Required Tools and Equipment (ETSI)
Chapter 1, "Install the Cisco ONS 15454 Shelf
Table 1-12 by verifying that each applicable
Cisco ONS 15454 DWDM Procedure Guide, Release 9.2
Completed
1-87