Cisco ONS 15454 Series Procedure Manual page 122

Required Tools and Equipment (ETSI)
Warning Connect the unit only to DC power source that complies with the safety extra-low voltage (SELV)
requirements in IEC 60950-1 based safety standards. Statement 1033
This product requires short-circuit (overcurrent) protection, to be provided as part of the building
Warning
installation. Install only in accordance with national and local wiring regulations. The short-circuit
(overcurrent) protection rating must not exceed 40A. Statement 1045
Warning A readily accessible two-poled disconnect device must be incorporated in the fixed wiring. Statement
1022
This unit might have more than one power supply connection. All connections must be removed to
Warning
de-energize the unit. Statement 1028
Caution Always use the supplied ESD wristband when working with a powered ONS 15454. For detailed
instructions on how to wear the ESD wristband, refer to the
and Grounding Guide.
Verify that the correct fuse and alarm panel is installed in the top mounting space:
Step 1
(ETSI only) Verify that the fuse rating does not exceed 40A.
•
The fuse rating for ANSI chassis must not exceed 30A.
•
Step 2 Depending on your type of shelf, connect the office ground to the 15454 ETSI or the 15454 ANSI
chassis. For detailed instructions on grounding, refer to the
and Grounding
Step 3 Depending on your shelf, complete the
on page 1-35
Complete the
Step 4
Step 5 Continue with the
Stop. You have completed this procedure.
Cisco ONS 15454 DWDM Procedure Guide, Release 9.2
1-34
Guide.
or the "DLP-G18 Connect Office Power to the ONS 15454 ANSI" task on page
"DLP-G19 Turn On and Verify Office Power" task on page
"NTP-G8 Install the Fan-Tray Assembly" procedure on page
Chapter 1
Cisco ONS Electrostatic Discharge (ESD)
Cisco ONS Electrostatic Discharge (ESD)
"DLP-G17 Connect Office Power to the ONS 15454 ETSI" task
Install the Cisco ONS 15454 Shelf Assembly
1-39.
1-41.
78-19286-01
1-37.